Saw Blade Sharpening Machine, Grinder Wet Stone Grinder 80-700mm Circle Saw Blade Diamond Carbide Water Mill 250W

Amazon.co.uk Price: £138.99 (as of 13/11/2019 16:39 PST- Details)

The machine construction is strong and it can be worked with a maximum diameter of φ700mm.
The specially equipped motor has a very good running speed, which can work very well with the diamond grinding wheel.
The machine is designed for sharpening various carbide saws. It is also suitable for other materials such as plastic, wood, aluminum alloys for various purposes such as furniture production, decoration, etc.

Description

Specification:
Power: 250W
Voltage: 220V
Running speed: 2850 rpm
Setting angle of the wheel: ± 20 °
Handle rotation angle: 30 degrees from left and 45 degrees from right side
Working diameter: 80-700mm
Grinding wheel size: 4.92 inches
Bore size of the grinding wheel 1.26 inches
Working diameter 80-700mm
way of working:
1, lose the fascia, then adjust the angle of the sanding blade and fasten.
2, adjustment of the central axis.
Turn the center axis to the sanding sheet.
Slide the center axis to the right.
Install the saw blade, turn the wheel, and decide the position of the saw teeth.
Turn the turntable to ensure the angle of the sanding sheet.
The crossing angle between the grinding surface and the working surface is about 5.
3, adjustment of the positioning arrangement.
Set the saw blade to the best grinding position and rotate the positioning frame and instrument panel.
Adjust the adjusting pin to the correct base of the saw teeth and leave the gap of the grinding amount, fix the fixed screw.
Fourth, set the center axis to the same gap of the ground amount to the right.
Finally, with all parts attached, the hand-held saw blade is ground.

Safety instructions:
Should be the standard voltage; We must strictly pay attention to a good floor, install residual current device.
The machine should be placed in a dry, clean, even and parallel location.
Release the round plate and then adjust the saw blade angle.
Before operation, check all parts that need to be locked.
Switch off the power after work.
After the machine runs well, you can start working.

The machine construction is strong and it can be worked with a maximum diameter of φ700mm.
The specially equipped motor has a very good running speed, which can work very well with the diamond grinding wheel.
The machine is designed for sharpening various carbide saws. It is also suitable for other materials such as plastic, wood, aluminum alloys for various purposes such as furniture production, decoration, etc.
The direction of the grinding should be parallel with the diamond grinding wheel, better for grinding the rear tooth surface. Its bezel can support the teeth of saw blades and other parts to prevent cracks and improve the quality of grinding.
The three-dimensional slide structures with multiple pivoting angles are suitable for grinding saw blades of hard alloys with many specifications and purposes. This allows the grinder to ensure high accuracy and ease of use under all conditions.